Document IIF

Analyses thermodynamiques d'un cycle de pompe à chaleur au CO2 transcritique amélioré par un éjecteur, avec injection de vapeur.

Thermodynamic analyses on an ejector enhanced CO2 transcritical heat pump cycle with vapor-injection.

Auteurs : BAI T., YAN G., YU J.

Type d'article : Article, Article de la RIF

Résumé

In this paper, an ejector enhanced vapor injection CO2 transcritical heat pump cycle with sub-cooler (ESCVI) for heating application in cold regions is proposed. The thermodynamic analysis using energetic and exegetic methods is carried out to predict the performance characteristics of the ejector enhanced cycle, and then compared with those of the conventional vapor injection heat pump cycle with sub-cooler (SCVI). The simulation results demonstrate that the ejector enhanced cycle exhibits better performance than the conventional vapor injection cycle under the specified operating conditions. The improvements of the maximum system COP and volumetric heating capacity could reach up to 7.7% and 9.5%, respectively. Exergetic analysis indicates that the largest exergy destruction ratio is generated at the compressor followed by the evaporator and gas cooler. Additionally, the exergy efficiency of the ejector is introduced to quantify the effectiveness of the exergy recovery process, which may be a new criterion to evaluate the performance of the ejector enhanced vapor compression cycle.

Documents disponibles

Format PDF

Pages : 22-34

Disponible

  • Prix public

    20 €

  • Prix membre*

    Gratuit

* meilleur tarif applicable selon le type d'adhésion (voir le détail des avantages des adhésions individuelles et collectives)

Détails

  • Titre original : Thermodynamic analyses on an ejector enhanced CO2 transcritical heat pump cycle with vapor-injection.
  • Identifiant de la fiche : 30015662
  • Langues : Anglais
  • Source : International Journal of Refrigeration - Revue Internationale du Froid - vol. 58
  • Date d'édition : 10/2015

Liens


Voir d'autres articles du même numéro (23)
Voir la source