Partager

Amélioration du transfert de chaleur dans un tube hélicoïdal et micro-aileté tridimensionnel.

Heat transfer augmentation in 3D internally finned and microfinned helical tube.

Auteurs : LI L., CUI W., LIAO Q., et al.

Type d'article : Article

Résumé

Experiments were performed to investigate the single-phase flow and flow-boiling heat transfer augmentation in 3D internally finned and micro-finned helical tubes. The tests for single-phase flow heat transfer augmentation are carried out in helical tubes with a curvature of 0.0663 and a length of 1.15 m, and the examined range of the Reynolds number varies from 1000 to 8500. Within the applied range of Reynolds number, compared with the smooth helical tube, the average heat transfer augmentation ratio for the two finned tubes is 71 and 103%, but associated with a flow resistance increase of 90 and 140%, respectively. A higher fin height gives a higher heat transfer rate and a larger friction flow resistance. The tests for flow-boiling heat transfer are carried out in 3D internally micro-finned helical tube with a curvature of 0.0605 and a length of 0.668 m. Compared with that in the smooth helical tube, the boiling heat transfer coefficient in the 3D internally micro-finned helical tube is increased by 40-120% under varied mass flow rate and wall heat flux conditions, meanwhile, the flow resistance is increased by 18-119%, respectively.

Détails

  • Titre original : Heat transfer augmentation in 3D internally finned and microfinned helical tube.
  • Identifiant de la fiche : 2006-0156
  • Langues : Anglais
  • Source : International Journal of Heat and Mass Transfer - vol. 48 - n. 10
  • Date d'édition : 05/2005

Liens


Voir d'autres articles du même numéro (5)
Voir la source

Indexation