Résumé
The gas injection technology had been developed to enhance the performance of the single cylinder rotary compressor at high compression ratio. However, the improvement of current designs was unsatisfactory because of the limited effective mass injected. A novel end-plate injection structure with check valve for rotary compressor was proposed and its advantages were confirmed in a previous study. In order to enlarge the injection port, increase the gas injected, and eventually increase performance enhancement, the general expressions of the envelopes and areas of the injection regions are developed based on an analytical geometry method in this paper. Based on them, the effects of the design parameters, such as the eccentricity and the thickness of the rolling piston, on the injection region area are investigated. Finally, an optimal design method for the rotary compressor oriented to proposed end-plate gas injection with check valve is raised. As a conclusion, for an arbitrary rotary compressor with designated cylinder radius, the area of the injection region reaches the maximum when the thickness of the rolling piston is equal to two times of the eccentricity.
Documents disponibles
Format PDF
Pages : 516-522
Disponible
Prix public
20 €
Prix membre*
Gratuit
* meilleur tarif applicable selon le type d'adhésion (voir le détail des avantages des adhésions individuelles et collectives)
Détails
- Titre original : Optimal design of rotary compressor oriented to end-plate gas injection with check valve.
- Identifiant de la fiche : 30023580
- Langues : Anglais
- Source : International Journal of Refrigeration - Revue Internationale du Froid - vol. 88
- Date d'édition : 04/2018
- DOI : http://dx.doi.org/10.1016/j.ijrefrig.2018.02.029
Liens
Voir d'autres articles du même numéro (57)
Voir la source
Indexation
-
CFD analysis and experiment study of the rotary...
- Auteurs : DENG L., LIANG S., XU J., et al.
- Date : 11/07/2016
- Langues : Anglais
- Source : 2016 Purdue Conferences. 23rd International Compressor Engineering Conference at Purdue.
- Formats : PDF
Voir la fiche
-
Swing compressor with injection mechanism that ...
- Auteurs : WADA R., TOKUDA E., IRIKAWA K., SUNAHARA Y., INADA Y., ENDO C., YANAGISAWA M.
- Date : 15/07/2022
- Langues : Anglais
- Source : 2022 Purdue Conferences. 26th International Compressor Engineering Conference at Purdue.
- Formats : PDF
Voir la fiche
-
Impact of suction and injection gas superheat d...
- Auteurs : DECHESNE B., LEMORT V., NADRI M., et al.
- Date : 09/07/2018
- Langues : Anglais
- Source : 2018 Purdue Conferences. 17th International Refrigeration and Air-Conditioning Conference at Purdue.
- Formats : PDF
Voir la fiche
-
A novel capacity modulation technology for heat...
- Auteurs : WANG B., HAN L., SHI W., et al.
- Date : 12/07/2010
- Langues : Anglais
- Source : 2010 Purdue Conferences. 13th International Refrigeration and Air-Conditioning Conference at Purdue.
- Formats : PDF
Voir la fiche
-
Analysis of the refrigerant‐side temperature pr...
- Auteurs : SIERES J., ORTEGA I., CERDEIRA F., SANTOS J. M., ALVAREZ E.
- Date : 21/08/2023
- Langues : Anglais
- Source : Proceedings of the 26th IIR International Congress of Refrigeration: Paris , France, August 21-25, 2023.
- Formats : PDF
Voir la fiche