Étude de la performance de fusion d'un matériau à changement de phase basée sur une unité de stockage d'énergie thermique à calandre et à tube avec une configuration d'ailettes rectangulaires.
Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration.
Résumé
A case study on the melting performance of a shell-and-tube phase change material (PCM) thermal energy storage unit with a novel rectangular fin configuration is conducted in this paper. Paraffin wax and circulated water are employed as the PCM and heat transfer fluid (HTF), respectively. It can be observed that the melting performance could be significantly improved by using rectangular fins. Melting photographs demonstrate that the melting of the PCM is firstly dominated by heat conduction; then, the melting rate is improved further due to natural convection. Moreover, the results illustrate that the influence of the inlet HTF temperature on the melting performance is significantly greater than that of the inlet HTF flow rate. The liquid fraction of paraffin wax in the PCM unit with a higher inlet HTF temperature is always higher than that with a lower inlet HTF temperature at the same time. The total charging time is reduced by 62.38% and the average charging rate is increased by 165.51% when the inlet HTF temperature is increased from 57 °C to 68 °C. As a result, a higher value of the inlet HTF temperature and a lower value of the HTF flow rate are able to improve the energy efficiency of the PCM unit with a rectangular fin configuration.
Documents disponibles
Format PDF
Pages : 15 p.
Disponible
Gratuit
Détails
- Titre original : Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration.
- Identifiant de la fiche : 30030866
- Langues : Anglais
- Sujet : Technologie
- Source : Energies - vol. 15 - n. 21
- Éditeurs : MDPI
- Date d'édition : 11/2022
- DOI : http://dx.doi.org/10.3390/en15218200
Liens
Voir d'autres articles du même numéro (29)
Voir la source
-
Mobilized Thermal Energy Storage for Waste Heat...
- Auteurs : KUTA M.
- Date : 11/2022
- Langues : Anglais
- Source : Energies - vol. 15 - n. 22
- Formats : PDF
Voir la fiche
-
Performance analysis of thermal energy storage ...
- Auteurs : CARON-SOUPART A., FOURMIGUE J. F., MARTY P., et al.
- Date : 05/04/2016
- Langues : Anglais
- Source : Applied Thermal Engineering - vol. 98
Voir la fiche
-
On the effect of eccentricity of a horizontal t...
- Auteurs : YAZICI M. Y., AVCI M., AYDIN O., et al.
- Date : 03/2014
- Langues : Anglais
- Source : Applied Thermal Engineering - vol. 64 - n. 1-2
Voir la fiche
-
Experimental study on heat storage in paraffin ...
- Auteurs : LUCA C., DRAGOMIR-STANCIU D., DUMITRASCU G., et al.
- Date : 2015
- Langues : Anglais
- Source : Buletinul Institutului politehnic din Iasi, Sectia Constructii de Masini - vol. 61 - n. 2
Voir la fiche
-
Multiobjective Optimization of Cement-Based Pan...
- Auteurs : BRE F., CAGGIANO A., KOENDERS E. A. B.
- Date : 07/2022
- Langues : Anglais
- Source : Energies - vol. 15 - n. 14
- Formats : PDF
Voir la fiche