Modélisation inverse pour simuler les impacts des anomalies des équipements à compression de vapeur. 2. Modélisation et validation du système.

Inverse modeling to simulate fault impacts for vapor compression equipment. 2. System modeling and validation.

Numéro : pap. 2110

Auteurs : CHEUNG H., BRAUN J. E.

Résumé

This paper utilizes the component models described in a companion paper to develop a full system inverse model for normal and faulty performance of vapor compression cooling and heating equipment. Algorithms to simulate different faults, such as loss of refrigerant charge, compressor valve leakage, liquid line restriction, etc. are presented. Component model parameters were estimated from laboratory experimental data without complete knowledge about the component characteristics. The system model was tuned to offset the bias that resulted from model simplifications. The method was carried out with data from a 3-ton R410A packaged unit with fixed orifice expansion, operating with faults such as incorrect refrigerant charge and heat exchanger fouling. The system model outputs had good agreement with the experimental data. The impacts of faults on performance determined through simulation are also presented.

Documents disponibles

Format PDF

Pages : 10 p.

Disponible

  • Prix public

    20 €

  • Prix membre*

    15 €

* meilleur tarif applicable selon le type d'adhésion (voir le détail des avantages des adhésions individuelles et collectives)

Détails

  • Titre original : Inverse modeling to simulate fault impacts for vapor compression equipment. 2. System modeling and validation.
  • Identifiant de la fiche : 30006312
  • Langues : Anglais
  • Source : 2012 Purdue Conferences. 14th International Refrigeration and Air-Conditioning Conference at Purdue.
  • Date d'édition : 16/07/2012

Liens


Voir d'autres communications du même compte rendu (195)
Voir le compte rendu de la conférence