Recherches dans le développement d'adsorbants composites appliqués à une pompe à chaleur à adsorption.
Development research on composite adsorbents applied in adsorption heat pump.
Auteurs : HUANG H., OIKE T., WATANABE F., et al.
Type d'article : Article
Résumé
A novel adsorbent design technique based on the concept of Kelvin equation was proposed to develop hydrophilic adsorbent applicable to water vapor adsorption heat pump (AHP) for high performance. In the process, the composite adsorbent was prepared after silica gel was synthesized in the pores of activated carbons by impregnating activated carbons in sodium silicate solution. Two kinds of activated carbons were tested to produce composite adsorbent and to investigate the performance by measuring the adsorption isotherms of water vapor and pore structure characteristics. All adsorption isotherms of the silica impregnated activated carbons prepared shifted to a lower region of water vapor pressure compared to those of the raw activated carbons. The volume-based amount of adsorption in the AHP operation range (f = 0.1-0.4) for the adsorbents prepared at sodium silicate solution concentration of 10 wt.% and impregnating time of 48 h are 5.88 and 2.62 times that of the raw activated carbons (AC1 and AC2), respectively. Based on the Kelvin equation, it is clarified that the contact angle and the volume of pore radius greater than 1.2 nm decrease with the increase of sodium silicate solution concentration for the novel composite adsorbents, which contributes the isothermals shift to lower relative pressure range. [Reprinted with permission from Elsevier. Copyright, 2010].
Détails
- Titre original : Development research on composite adsorbents applied in adsorption heat pump.
- Identifiant de la fiche : 30001446
- Langues : Anglais
- Source : Applied Thermal Engineering - vol. 30 - n. 10
- Date d'édition : 07/2010
- DOI : http://dx.doi.org/10.1016/j.applthermaleng.2010.01.036
Liens
Voir d'autres articles du même numéro (9)
Voir la source
Indexation
-
Comparison among three adsorption pairs for usi...
- Auteurs : SAN J. Y., LIN W. M.
- Date : 06/2008
- Langues : Anglais
- Source : Applied Thermal Engineering - vol. 28 - n. 8-9
Voir la fiche
-
Annular-finned sorption bed heat exchanger desi...
- Auteurs : RAYMOND A., GARIMELLA S.
- Date : 06/04/2011
- Langues : Anglais
- Source : Sources/sinks Alternative to the Outside Air for Heat Pump and Air-conditioning Techniques (Alternative Sources - AS), Padua, Italy, April 5-7, 2011. / International Sorption Heat Pump Conference (ISHPC11), Padua, Italy, April 6-8, 2011.
- Formats : PDF
Voir la fiche
-
Transfert de chaleur accompagné d'adsorption/dé...
- Auteurs : WATANABE F., WATABE Y., KATSUYAMA H., KOZUKA J., HASATANI M., MARUMO C.
- Date : 1993
- Langues : Japonais
- Source : Kagaku Hogaku Ronbunshu - vol. 19 - n. 1
Voir la fiche
-
Absorption cooling cycles for adsorbent-adsorba...
- Auteurs : LOH W. S., NG K. C., CHAKRABORTY A., et al.
- Date : 20/05/2009
- Langues : Anglais
- Source : ACRA-2009. The proceedings of the 4th Asian conference on refrigeration and air conditioning: May 20-22, 2009, Taipei, R.O.C.
- Formats : PDF
Voir la fiche
-
Constraints of adsorption cooling cycles workin...
- Auteurs : SAHA B. B., SHARKAWY I. I. el-, CHAKRABORTY A., et al.
- Date : 05/04/2008
- Langues : Anglais
- Source : Cryogenics and refrigeration. Proceedings of ICCR'2008.
Voir la fiche