Partager

Refroidissement du bord de fuite d'une aube de turbine à gaz avec obturations perforées de façon inclinée.

Trailing edge cooling of a gas turbine blade with perforated blockages with inclined holes.

Auteurs : CHUNG H., PARK J. S., SOHN H. S., et al.

Type d'article : Article

Résumé

An improved hole array to enhance the cooling performance of a perforated blockage was proposed in this paper. The internal passage in the trailing region of the blade was modeled as a wide square channel with three parallel blockages. Various configurations of perforated blockages were tested with a fixed Reynolds number based on the channel hydraulic diameter. The baseline design had holes positioned along the centerline of the blockage in the lateral direction, and the array pattern, hole size, and hole direction were manipulated to enhance the cooling performance. Experiments were performed to obtain information on heat transfer and pressure loss. A naphthalene sublimation method was adopted to obtain detailed heat transfer distributions on the surfaces, using the correlation between heat and mass transfer. The pressure was measured at several points to evaluate the pressure loss. The proposed inclined hole array showed noticeably improved cooling performance, as much as 50% higher than the conventional configuration.

Détails

  • Titre original : Trailing edge cooling of a gas turbine blade with perforated blockages with inclined holes.
  • Identifiant de la fiche : 30011513
  • Langues : Anglais
  • Source : International Journal of Heat and Mass Transfer - vol. 73
  • Date d'édition : 06/2014
  • DOI : http://dx.doi.org/10.1016/j.ijheatmasstransfer.2014.01.062

Liens


Voir d'autres articles du même numéro (12)
Voir la source

Indexation