Partager

Document IIF

Simulation numérique et modélisation des transferts de chaleur et de masse dans un évaporateur plat rainuré à film tombant.

Numerical simulation and modeling of the heat and mass transfer in a grooved flat falling film evaporator.

Auteurs : COLLIGNON R., STUTZ B.

Type d'article : Article de la RIF

Résumé

Falling film plate exchanger are used in a wide range of systems thanks to their high heat and mass transfer performance for a low cost. In this study, a grooved plate is considered for its ability to improve the wetting of the surface compared to a smooth plate. To characterize the heat transfer and evaporation rate of the system, a numerical model has been developed to take account of the new geometry and has been confronted to experimental results. Despite the high aspect ratio of the falling film, the fin effect is very high on the heat transfer and on the vaporization process due to the triple contact lines. The principal aim of this study is to develop a simple and light model able to accurately describe the heat and mass transfer behavior of film while it flows down in the grooves of the vertical plate of the evaporator. The influence of the operating conditions on the evaporator effectiveness are evaluated thanks to numerical investigations.

Documents disponibles

Format PDF

Pages : 148-157

Disponible

  • Prix public

    20 €

  • Prix membre*

    Gratuit

* meilleur tarif applicable selon le type d'adhésion (voir le détail des avantages des adhésions individuelles et collectives)

Détails

  • Titre original : Numerical simulation and modeling of the heat and mass transfer in a grooved flat falling film evaporator.
  • Identifiant de la fiche : 30030899
  • Langues : Anglais
  • Sujet : Technologie
  • Source : International Journal of Refrigeration - Revue Internationale du Froid - vol. 146
  • Date d'édition : 02/2023
  • DOI : http://dx.doi.org/10.1016/j.ijrefrig.2022.10.021

Liens


Voir d'autres articles du même numéro (41)
Voir la source

Indexation