Résumé
A four-zone flow boiling model is presented to describe saturated flow boiling heat transfer mechanisms in a microchannel of rectangular cross-section. The boiling process in the microchannel is assumed to be a cyclic passage of four zones: (i) liquid-slug zone, (ii) elongated bubble zone, (iii) partially-dryout zone, and (iv) fully-dryout zone. The existence of the partially-dryout zone in this model is proposed to take into consideration of corner effects on boiling heat transfer in the microchannel. To verify this new model, an experimental study was carried out to investigate flow boiling heat transfer of water in a microchannel having a rectangular cross-section with a hydraulic diameter of 137 micron. (202 microm. in width and 104 microm. in depth) with a length of 30 mm under three-side heating condition. The data for bubble nucleation frequency was correlated in terms of the Boiling number, which was used to determine the heat transfer coefficient. It is found that the present four-zone flow boiling model successfully predicts trends of boiling heat transfer data in a microchannel with a rectangular cross-section, having a sharp peak at low vapour quality depending on the mass flow rate. The predictions of flow boiling heat transfer coefficient in the microchannel are found in good agreement with experimental data with a MAE of 13.9%. [Reprinted with permission from Elsevier. Copyright, 2010].
Détails
- Titre original : A four-zone model for saturated flow boiling in a microchannel of rectangular cross-section.
- Identifiant de la fiche : 2010-1805
- Langues : Anglais
- Source : International Journal of Heat and Mass Transfer - vol. 53 - n. 17-18
- Date d'édition : 08/2010
- DOI : http://dx.doi.org/10.1016/j.ijheatmasstransfer.2010.04.001
Liens
Voir d'autres articles du même numéro (1)
Voir la source
Indexation
-
Thèmes :
Mesures thermodynamiques;
Transfert de chaleur - Mots-clés : Microcanal; Transfert de chaleur; Experimentation; Écoulement; Échangeur de chaleur; Ébullition
-
Two-phase pressure drop and flow boiling heat t...
- Auteurs : AYUB Z. H., AYUB A. H., RIBATSKI G., et al.
- Date : 03/2017
- Langues : Anglais
- Source : International Journal of Refrigeration - Revue Internationale du Froid - vol. 75
- Formats : PDF
Voir la fiche
-
Subcooled flow boiling heat transfer and associ...
- Auteurs : CHANG W. R., CHEN C. A., KE J. H., et al.
- Date : 11/2010
- Langues : Anglais
- Source : International Journal of Heat and Mass Transfer - vol. 53 - n. 23-24
Voir la fiche
-
Experimental and numerical study of the compact...
- Auteurs : GLAZAR V., FRANKOVIC B., TRP A.
- Date : 03/2015
- Langues : Anglais
- Source : International Journal of Refrigeration - Revue Internationale du Froid - vol. 51
- Formats : PDF
Voir la fiche
-
An experimental investigation of air cooling th...
- Auteurs : YANG K. S., LI S. L., CHEN I. Y., et al.
- Date : 12/2010
- Langues : Anglais
- Source : International Journal of Heat and Mass Transfer - vol. 53 - n. 25-26
Voir la fiche
-
Effet de l'huile lubrifiante sur le transfert d...
- Auteurs : SAITOH S., DANG C., HIHARA E.
- Date : 2013
- Langues : Japonais
- Source : Transactions of the Japan Society of Refrigerating and Air Conditioning Engineers - vol. 30 - n. 4
Voir la fiche