Partager

Brumisation par évaporation de surfaces lisses ou microporeuses.

Evaporative spray cooling of plain and microporous coated surfaces.

Auteurs : KIM J. H., YOU S. M., CHOI S. U. S.

Type d'article : Article

Résumé

Experiments were performed on air and evaporative spray cooling of plain and microporous coated surfaces on flat and cylindrical heaters. Micron-size aluminium particles were used to build the microporous structures on the heated surfaces. To analyse the evaporative cooling, heat transfer curves were obtained in the form of the wall temperature difference versus heat flux. The heat transfer coefficients were also determined as a function of heat flux. Three water flow rates(1.25, 1.75 and 2.40 ml/min) were tested for the flat heater and one rate (3.0 ml/min) for the cylindrical heater, maintaining the air pressure of 7 psig (48 kPa) at the inlet of the nozzle. The effect of different particle sizes in the coating was also tested to optimise the microporous coating technique. Spraying water droplets on the microporous coating surface enhanced the heat removal due to the capillary pumping phenomenon through the microporous cavities connecting each other. The evaporative spray cooling increased the heat transfer coefficient by up to 400% relative to that of the uncoated surface cooled by dry air, and this enhancement was maintained at high heat fluxes by using microporous surfaces.

Détails

  • Titre original : Evaporative spray cooling of plain and microporous coated surfaces.
  • Identifiant de la fiche : 2005-0092
  • Langues : Anglais
  • Source : International Journal of Heat and Mass Transfer - vol. 47 - n. 14-16
  • Date d'édition : 07/2004

Liens


Voir d'autres articles du même numéro (13)
Voir la source

Indexation