Partager

Refroidissement par aspersion à tuyères multiples pour des applications à flux thermique élevé dans un système à boucle fermée.

Multi-nozzle spray cooling for high heat flux applications in a closed loop system.

Auteurs : TAN Y. B., XIE J. L., DUAN F., et al.

Type d'article : Article

Résumé

A modified R134a closed loop spray cooling system is used to investigate the spray cooling thermal performance of a multi-nozzle plate. The nozzle plate consists of six jet-swirl nozzles, covering a sprayed area of 1 × 2 cm². The nozzles are customized in the 1.9 mm thick nozzle plate, so that they are flushed with the plate surface. The spray height from the plate to the impact area of 8.8 mm is determined by the spray angle and coverage area. Power input to the heater copper block was set to obtain a heat flux variation from 35 to 165 W/cm². The differential pressure across the nozzle plate ranged from 3.87 to 4.74 bar. Temperatures at a particular heat flux, under steady state conditions, were collected over a range of flow rates for analysis on the thermal performance of spray cooling using the multi-nozzle plate. The highest heat transfer coefficient of 39,000 W/m² K was observed at heat flux of 145 W/cm² with a surface temperature of 48°C. The incidence of critical heat flux can be observed when the power input causes the heat flux to reach above 165 W/cm². A generalized correlation is developed for the dimensionless heat flux as a function of dimensionless mass ?ow rate, and wall superheat degree, along with the Weber number and the Jacob number.

Détails

  • Titre original : Multi-nozzle spray cooling for high heat flux applications in a closed loop system.
  • Identifiant de la fiche : 30007839
  • Langues : Anglais
  • Source : Applied Thermal Engineering - vol. 54 - n. 2
  • Date d'édition : 05/2013
  • DOI : http://dx.doi.org/10.1016/j.applthermaleng.2013.01.033

Liens


Voir d'autres articles du même numéro (5)
Voir la source

Indexation