Démonstration de faisabilité de l’utilisation de joints adhésifs pour des applications de chauffage, de ventilation, de conditionnement d'air et de froid.
Proof-of-Concept Testing of Adhesive Joints for HVAC&R Applications.
Numéro : No 332
Auteurs : LIU H., GEOGHEGAN P. J., WEIBEL J. A., ZIVIANI D., GROLL E. A.
Résumé
The formation of joints is a critical process in HVAC&R component manufacturing and system assembly. Brazed joints are the most commonly used, but there are several alternative methods including mechanical compression, press, and push joints. Adhesive joints have not been widely explored or evaluated for use in HAVC&R systems. In this study, a review of different joint types reveals that adhesive bonding is a promising joining method due to potential benefits in energy use, cost savings, and leakage reduction. In order to demonstrate an application procedure and explore the feasibility of adhesive joints, two proof-of-concept tests were performed. First, tube-to-tube joints were installed in a heat pump dryer system to confirm that adhesive can hold the system pressure without affecting performance. Second, adhesively bonded U-bend joint samples were tested using a shaker table following an ISO standard and benchmarked against brazed joint samples. There was no failure or wear observed for the adhesive or brazed joints. These proof-of-concept tests indicate that there is potential for use of adhesive joints to replace brazed joints in HVAC&R applications, which merits further investigation.
Documents disponibles
Format PDF
Pages : 10 p.
Disponible
Gratuit
Détails
- Titre original : Proof-of-Concept Testing of Adhesive Joints for HVAC&R Applications.
- Identifiant de la fiche : 30030104
- Langues : Anglais
- Sujet : Technologie
- Source : 13th IEA Heat Pump Conference 2021: Heat Pumps – Mission for the Green World. Conference proceedings [full papers]
- Date d'édition : 31/08/2021
Liens
Voir d'autres communications du même compte rendu (198)
Voir le compte rendu de la conférence
Indexation
-
Pressure equipment for refrigerating systems an...
- Auteurs : AFNOR, CEN
- Date : 02/2002
- Langues : Français
Voir la fiche
-
Connessioni meccaniche alternative alla brasatura.
- Auteurs : GRASSI M.
- Date : 04/2012
- Langues : Italien
- Source : Industria & Formazione - vol. 36 - n. 358
- Formats : PDF
Voir la fiche
-
Which polymers should be used in heat pumps and...
- Auteurs : FREDERIKSEN K., SOLMS N. von, NEELA V.
- Date : 07/09/2008
- Langues : Anglais
- Source : 8th IIR-Gustav Lorentzen Conference on Natural Working Fluids (GL2008)
- Formats : PDF
Voir la fiche
-
Assessment of leakage rate and durability of fi...
- Auteurs : LAWRENCE N., RAJ S., ELBEL S.
- Date : 09/2018
- Langues : Anglais
- Source : 1st IIR international conference on the application of HFO refrigerants, Birmingham, September 2-5 2018.
- Formats : PDF
Voir la fiche
-
Assessment of leakage rate and durability of fi...
- Auteurs : LAWRENCE N., RAJ S., ELBEL S.
- Date : 09/2018
- Langues : Anglais
- Source : 1st IIR international conference on the application of HFO refrigerants, Birmingham, September 2-5 2018.
- Formats : PDF
Voir la fiche