Partager

Étude expérimentale du refroidissement par aspersion sur des surfaces lisses et à micro-structures.

Experimental investigation of spray cooling on smooth and micro-structured surfaces.

Auteurs : ZHANG Z., JIANG P. X., OUYANG X. L., et al.

Type d'article : Article

Résumé

The heat transfer during spray cooling was studied experimentally using deionized water to investigate the spray characteristics and the differences between spray cooling on smooth and enhanced silicon surfaces with micro-structures (characteristic size 25–200 µm). The spray cooling experiments show that the heat transfer was not significantly greater for the micro-structured surfaces than for the smooth surface in the flooded region, but was much greater in the thin film and partial dryout regions. The micro-structured surface with larger characteristic sizes had a smaller area enhancement factor and worse heat transfer rates. However, on the micro-structured surface with much smaller characteristic sizes, most droplets were not able to completely enter the bottom of the micro grooves since the groove size was smaller than most of the droplets and the heat transfer surface could not be fully wetted. There is an optimal groove depth corresponding to a given droplet parameter, groove width and stud size that gives the best heat transfer rates. The wall temperature increase and the temperature fluctuations are small in the boiling regime as the power increases for the micro-structured surfaces.

Détails

  • Titre original : Experimental investigation of spray cooling on smooth and micro-structured surfaces.
  • Identifiant de la fiche : 30011669
  • Langues : Anglais
  • Source : International Journal of Heat and Mass Transfer - vol. 76
  • Date d'édition : 09/2014
  • DOI : http://dx.doi.org/10.1016/j.ijheatmasstransfer.2014.04.010

Liens


Voir d'autres articles du même numéro (7)
Voir la source

Indexation