Résumé
Wet cooling towers have been widely employed to remove waste heat from power plants. However, these towers usually operate with defects especially in long-time running power plants. Therefore, the influences of the defects, including the conditions of packing blockage, nozzles blockage and nozzles drop, on cooling tower performance was investigated experimentally in this study. Under nozzles defect conditions, 15% nozzles were dropped or blocked in cooling tower. Under packing defect conditions, the packing blocked area was equal to the decreased drenching area under nozzles defect conditions. The performance of cooling tower under normal condition (without defects) and defect conditions is investigated with different inlet air/water parameters. According to the results, under normal conditions and defect conditions, the efficiency coefficient, ?, and tower characteristic, KaV/L, decrease with the increase of water-to-air ratio. Compared with normal conditions, the tower characteristics decrease slightly under nozzles blockage and packing blockage conditions, but decrease more than 60% under nozzles drop conditions.
Détails
- Titre original : Experimental investigation on the performance of wet cooling towers with defects in power plants.
- Identifiant de la fiche : 30014863
- Langues : Anglais
- Source : Applied Thermal Engineering - vol. 78
- Date d'édition : 03/2015
- DOI : http://dx.doi.org/10.1016/j.applthermaleng.2014.12.032
Liens
Voir d'autres articles du même numéro (19)
Voir la source
Indexation
-
A novel natural draft dry cooling system with b...
- Auteurs : KONG Y., WANG W., YANG L., et al.
- Date : 02/2017
- Langues : Anglais
- Source : International Journal of thermal Sciences - vol. 112
Voir la fiche
-
Flow and heat transfer characteristics of indir...
- Auteurs : WU X. P., YANG L. J., DU X. Z., et al.
- Date : 05/2014
- Langues : Anglais
- Source : International Journal of thermal Sciences - vol. 79
Voir la fiche
-
Effect of wind on performance of a dry-cooling ...
- Auteurs : PREEZ A. F. du, KROGER D. G.
- Date : 03/1993
- Langues : Anglais
- Source : Heat Recov. Syst. CHP - vol. 13 - n. 2
Voir la fiche
-
Influence of non-uniform layout fillings on the...
- Auteurs : GAO M., ZHANG L., WANG N. N., et al.
- Date : 25/01/2016
- Langues : Anglais
- Source : Applied Thermal Engineering - vol. 93
Voir la fiche
-
Nozzle arrangement study for pre-cooling the in...
- Auteurs : PANG H., WANG M., GAO Q., CHENG S., LIU Z., GENG Z., ZHANG S., HE S., LIU T., ZHAO C., LIU W., GAO M.
- Date : 04/2023
- Langues : Anglais
- Source : International Journal of Refrigeration - Revue Internationale du Froid - vol. 148
- Formats : PDF
Voir la fiche