Document IIF
Imagerie thermique des matériaux à effet magnétocalorique pendant le fonctionnement d'un régénérateur actif magnétique.
Thermal imaging of active magnetic regenerator MCE materials during operation.
Numéro : sect. 3
Auteurs : SHASSERE B., ABDELAZIZ O., EVANS B., et al.
Résumé
An active magnetic regenerator (AMR) prototype was constructed that incorporates a Gd sheet into the regenerator wall to enable visualization of the system’s thermal transients. In this experiment, the thermal conditions inside the AMR are observed under a variety of operating conditions. An infrared (IR) camera is employed to visualize the thermal transients within the AMR. The IR camera is used to visually and quantitatively evaluate the temperature difference and thus giving means to calculate the performance of the system under the various operating conditions. Thermal imaging results are presented for two differing experimental test runs. Real time imaging of the thermal state of the AMR has been conducted while operating the system over a range of conditions. A 1 T twin-coil electromagnet (situated on a C frame base) is used for this experiment such that all components are stationary during testing. A modular, linear reciprocating system has been realized in which the effects of regenerator porosity and utilization factor can be investigated. To evaluate the performance variation in porosity and utilization factor the AMR housing was constructed such that the plate spacing of the Gd sheets may be varied. Each Gd sheet has dimensions of 38 mm wide and 66 mm long with a thickness of 1 mm and the regenerator can hold a maximum of 29 plates with a spacing of 0.25 mm. Quantitative and thermal imaging results are presented for several regenerator configurations.
Documents disponibles
Format PDF
Pages : 565-572
Disponible
Prix public
20 €
Prix membre*
Gratuit
* meilleur tarif applicable selon le type d'adhésion (voir le détail des avantages des adhésions individuelles et collectives)
Détails
- Titre original : Thermal imaging of active magnetic regenerator MCE materials during operation.
- Identifiant de la fiche : 30005608
- Langues : Anglais
- Source : 5th International Conference on Magnetic Refrigeration at Room Temperature (Thermag V). Proceedings: Grenoble, France, September 17-20, 2012.
- Date d'édition : 17/09/2012
Liens
Voir d'autres communications du même compte rendu (70)
Voir le compte rendu de la conférence
-
Modeling and experimental validation of a flat-...
- Auteurs : VUARNOZ D., KAWANAMI T.
- Date : 17/09/2012
- Langues : Anglais
- Source : 5th International Conference on Magnetic Refrigeration at Room Temperature (Thermag V). Proceedings: Grenoble, France, September 17-20, 2012.
- Formats : PDF
Voir la fiche
-
Validation of an active magnetic regenerator te...
- Auteurs : DIKEOS J., ROWE A.
- Date : 05/2013
- Langues : Anglais
- Source : International Journal of Refrigeration - Revue Internationale du Froid - vol. 36 - n. 3
- Formats : PDF
Voir la fiche
-
Development and experimental results from a 1 k...
- Auteurs : BAHL C. R. H., ENGELBRECHT K., ERIKSEN D., et al.
- Date : 01/2014
- Langues : Anglais
- Source : International Journal of Refrigeration - Revue Internationale du Froid - vol. 37 - n. 1
- Formats : PDF
Voir la fiche
-
An experimental comparison of four regenerators...
- Auteurs : LEGAIT U., GUILLOU F., KEDOUS-LEBOUC A., et al.
- Date : 17/09/2012
- Langues : Anglais
- Source : 5th International Conference on Magnetic Refrigeration at Room Temperature (Thermag V). Proceedings: Grenoble, France, September 17-20, 2012.
- Formats : PDF
Voir la fiche
-
An experimental comparison of four magnetocalor...
- Auteurs : LEGAIT U., GUILLOU F., KEDOUS-LEBOUC A., et al.
- Date : 01/2014
- Langues : Anglais
- Source : International Journal of Refrigeration - Revue Internationale du Froid - vol. 37 - n. 1
- Formats : PDF
Voir la fiche