Partager

Modeling of a hot gas bypass test block for centrifugal compressors.

Numéro : pap. 1549

Auteurs : GESSLER P. D, MATHISON M. M., BOWMAN A. J.

Résumé

The increasingly competitive building equipment and control industry pushes manufacturers to continually improve the performance and efficiency of their products to develop and maintain a competitive edge. Compressor development is an expensive endeavor, but the cost and time required for testing can be minimized by developing a model of the compressor test block to predict its behavior with a given prototype compressor at specified operating conditions. This paper presents a thermodynamic model of a hot gas bypass test block used to evaluate centrifugal compressor performance at a compressor development facility. The test block uses cooling towers to reject the heat of compression to outdoor air, and experience has shown that the range of achievable compressor test conditions can be limited by outdoor air temperature and humidity, which affect the heat transfer rate. Therefore, one goal of the model development was to provide a means for evaluating the feasibility of tests at given outdoor air conditions. A second goal of the model was to assist in selecting the orifice plate used in the orifice flow meter that measures mass flow through the compressor. The model assumes that the system operates at steady-state conditions and uses a compressor map to model expected prototype compressor performance. Therefore, this research focuses on the condenser and cooling tower models, which are the most important elements for predicting the impact of outdoor conditions on cycle performance. It is shown that the resulting model achieves agreement to within 2.5% of experimental data. The results for orifice differential pressure agree to within 0.35% of experimental data, providing a useful orifice selection routine.

Documents disponibles

Format PDF

Pages : 10 p.

Disponible

  • Prix public

    20 €

  • Prix membre*

    15 €

* meilleur tarif applicable selon le type d'adhésion (voir le détail des avantages des adhésions individuelles et collectives)

Détails

  • Titre original : Modeling of a hot gas bypass test block for centrifugal compressors.
  • Identifiant de la fiche : 30014239
  • Langues : Anglais
  • Source : 2014 Purdue Conferences. 22nd International Compressor Engineering Conference at Purdue.
  • Date d'édition : 14/07/2014

Liens


Voir d'autres communications du même compte rendu (138)
Voir le compte rendu de la conférence

Indexation