Ebullition en écoulement sous-refroidi et phénomène d'émission de microbulles dans un microcanal partiellement chauffé.

Subcooled flow boiling and microbubble emission boiling phenomena in a partially heated microchannel.

Auteurs : WANG G., CHENG P.

Type d'article : Article

Résumé

A simultaneous visualization and measurement study has been carried out to investigate subcooled flow boiling and microbubble emission boiling (MEB) phenomena of deionized water in a partially heated Pyrex glass microchannel, having a hydraulic diameter of 155 µm, which was integrated with a Platinum microheater. Effects of mass flux, inlet water subcooling and surface condition of the microheater on subcooled flow boiling in microchannels are investigated. It is found that MEB occurred at high inlet subcoolings and at high heat fluxes, where vapour bubbles collapsed into microbubbles after contacting with the surrounding highly subcooled liquid. In the fully-developed MEB regime where the entire microheater was covered by MEB, the mass flux, the inlet water subcooling and the heater surface condition have only small effects on the boiling curves. The occurrence of MEB in microchannel can remove a large amount of heat flux, as high as 14.41 MW/m2 at a mass flux of 883.8 kg/m2.s, with only a moderate rise in wall temperature. Therefore, MEB is a very promising method for cooling of microelectronic chips. Heat transfer in the fully-developed MEB in the microchannel is presented, which is compared with existing subcooled flow boiling heat transfer correlations for macrochannels. [Reprinted with permission from Elsevier. Copyright, 2008].

Détails

  • Titre original : Subcooled flow boiling and microbubble emission boiling phenomena in a partially heated microchannel.
  • Identifiant de la fiche : 2009-1055
  • Langues : Anglais
  • Source : International Journal of Heat and Mass Transfer - vol. 52 - n. 1-2
  • Date d'édition : 01/2009

Liens


Voir d'autres articles du même numéro (8)
Voir la source