Partager

Etude expérimentale de diverses géométries d'éjecteurs pour les systèmes transcritiques au R744.

Investigación en laboratorio de diferentes geometrías de eyector para sistemas de R744 transcríticos.

Auteurs : HAFNER A., LADAM Y., ANDRESEN T., et al.

Type d'article : Article

Résumé

This work describes measurement results of ejectors manufactured and experimentally investigated at SINTEF Energy Research/NTNU. The ejectors are experimentally investigated in an oil free R744 test facility in order to focus on the ejector properties and behaviour. Five different ejectors were experimentally investigated at equal boundary conditions. The results are promising with pressure lifts close to 9 bars at low mass entrainment ratios of 0.22 and suction pressure ratios of 1.24. At an higher mass entrainment ratio of 0.56 and suction pressure ratio of 1.14 a pressure lift of 6.5 bar was achieved with the smallest mixing section. Best performances were measured with the smallest mixing section diameter (3 mm) and a short nozzle with an ID of 0.9 mm. The results are very promising and show a very good COP improvement potential for R744 transcritical process deploying an ejector, as the pressure ratio for a compressor could be reduced by close to 10 bars.

Documents disponibles

Format PDF

Pages : 48-53

Disponible

  • Prix public

    20 €

  • Prix membre*

    15 €

* meilleur tarif applicable selon le type d'adhésion (voir le détail des avantages des adhésions individuelles et collectives)

Détails

  • Titre original : Investigación en laboratorio de diferentes geometrías de eyector para sistemas de R744 transcríticos.
  • Identifiant de la fiche : 30003141
  • Langues : Espagnol
  • Source : Frío Calor Aire acondicionado - vol. 39 - n. 439
  • Date d'édition : 09/2011

Liens


Voir d'autres articles du même numéro (5)
Voir la source

Indexation