Share

Experimental investigation of different ejector geometries for R744 transcritical systems.

Investigación en laboratorio de diferentes geometrías de eyector para sistemas de R744 transcríticos.

Author(s) : HAFNER A., LADAM Y., ANDRESEN T., et al.

Type of article: Article

Summary

This work describes measurement results of ejectors manufactured and experimentally investigated at SINTEF Energy Research/NTNU. The ejectors are experimentally investigated in an oil free R744 test facility in order to focus on the ejector properties and behaviour. Five different ejectors were experimentally investigated at equal boundary conditions. The results are promising with pressure lifts close to 9 bars at low mass entrainment ratios of 0.22 and suction pressure ratios of 1.24. At an higher mass entrainment ratio of 0.56 and suction pressure ratio of 1.14 a pressure lift of 6.5 bar was achieved with the smallest mixing section. Best performances were measured with the smallest mixing section diameter (3 mm) and a short nozzle with an ID of 0.9 mm. The results are very promising and show a very good COP improvement potential for R744 transcritical process deploying an ejector, as the pressure ratio for a compressor could be reduced by close to 10 bars.

Available documents

Format PDF

Pages: 48-53

Available

  • Public price

    20 €

  • Member price*

    15 €

* Best rate depending on membership category (see the detailed benefits of individual and corporate memberships).

Details

  • Original title: Investigación en laboratorio de diferentes geometrías de eyector para sistemas de R744 transcríticos.
  • Record ID : 30003141
  • Languages: Spanish
  • Source: Frío Calor Aire acondicionado - vol. 39 - n. 439
  • Publication date: 2011/09

Links


See other articles in this issue (5)
See the source

Indexing