
Document IIF
Mesurage de la circulation d’huile dans un système transcritique au R744 utilisant un éjecteur diphasique.
Measurement of oil circulation in transcritical R744 systems using two-phase ejector.
Numéro : pap. 1141
Auteurs : ZHU J., BOTTICELLA F., ELBEL S.
Résumé
The use of two-phase ejectors to recover expansion work to improve COP of transcritical R744 systems has been the subject of numerous investigations during the past decade. However, there is little understanding as to how oil in circulation in different parts of the system is affected when a two-phase ejector is used to replace the expansion valve. This paper presents detailed measurement results conducted on a transcritical R744 ejector system using polyalkylene glycol (PAG) oil, demonstrating that at the same test condition, the oil circulation rates (OCRs) in different parts of the system can easily vary by an order of magnitude. The highest OCRs of approximately 10% by mass were measured close to the evaporator inlet. The influence of compressor speed, ejector motive nozzle needle position and evaporator inlet metering valve opening on the OCRs was investigated and it is explained why these condition changes will result in variation of oil in circulation.
Documents disponibles
Format PDF
Pages : 8
Disponible
Prix public
20 €
Prix membre*
Gratuit
* meilleur tarif applicable selon le type d'adhésion (voir le détail des avantages des adhésions individuelles et collectives)
Détails
- Titre original : Measurement of oil circulation in transcritical R744 systems using two-phase ejector.
- Identifiant de la fiche : 30023506
- Langues : Anglais
- Source : 13th IIR Gustav Lorentzen Conference on Natural Refrigerants (GL2018). Proceedings. Valencia, Spain, June 18-20th 2018.
- Date d'édition : 18/06/2018
- DOI : http://dx.doi.org/10.18462/iir.gl.2018.1141
Liens
Voir d'autres communications du même compte rendu (177)
Voir le compte rendu de la conférence
Indexation
-
Thèmes :
CO2;
Lubrifiants;
Systèmes à éjection, cycle à air, cycle Stirling, autres cycles - Mots-clés : Polyalkylène glycol; Mesure; R744; Performance; Huile; Éjecteur; Cycle transcritique; CO2
-
Oil circulation rate in ejector cooling cycles.
- Auteurs : ZHU J., BOTTICELLA F., ELBEL S.
- Date : 06/04/2018
- Langues : Anglais
- Source : 5th IIR International Conference on Sustainability and the Cold Chain. Proceedings: Beijing, Chine, 6-8 avril 2018
- Formats : PDF
Voir la fiche
-
Performance assessment of an off-the-shelf R744...
- Auteurs : MINETTO S., BRIGNOLI R., BANASIAK K., et al.
- Date : 09/2013
- Langues : Anglais
- Source : Applied Thermal Engineering - vol. 59 - n. 1-2
Voir la fiche
-
Theoretical evaluation on effect of internal he...
- Auteurs : MA Y. T., WANG H. L., ZHANG Z. Y., et al.
- Date : 01/2013
- Langues : Anglais
- Source : Applied Thermal Engineering - vol. 50 - n. 1
Voir la fiche
-
Numerical simulation of two-phase flow pattern ...
- Auteurs : DANG C., ANAI S., HIHARA E.
- Date : 16/07/2012
- Langues : Anglais
- Source : 2012 Purdue Conferences. 14th International Refrigeration and Air-Conditioning Conference at Purdue.
- Formats : PDF
Voir la fiche
-
Les éjecteurs confirment leur potentiel.
- Auteurs : WIEDENMANN E.
- Date : 11/2015
- Langues : Français
- Source : La revue pratique du froid et du conditionnement d'air - n. 1040
Voir la fiche