Document IIF

Taux de circulation d’huile dans les cycles de refroidissement à éjecteur.

Oil circulation rate in ejector cooling cycles.

Numéro : pap. 10

Auteurs : ZHU J., BOTTICELLA F., ELBEL S.

Résumé

The use of two-phase ejectors to recover expansion work to improve COP of transcritical R744 systems has been the subject of numerous investigations during the past decade. However, there is little understanding as to how oil in circulation in different parts of the system is affected when a two-phase ejector is used to replace the expansion valve. This paper presents detailed measurement results conducted on a transcritical R744 ejector system using polyalkylene glycol (PAG) oil, demonstrating that at the same test condition, the oil circulation rates (OCRs) in different parts of the system can easily vary by an order of magnitude. The
highest OCRs of approximately 10% by mass were measured close to the evaporator inlet. The influence of compressor speed, ejector motive nozzle needle position and evaporator inlet metering valve opening on the OCRs was investigated and it is explained why these condition changes will result in variation of oil in circulation.

Documents disponibles

Format PDF

Pages : 10

Disponible

  • Prix public

    20 €

  • Prix membre*

    Gratuit

* meilleur tarif applicable selon le type d'adhésion (voir le détail des avantages des adhésions individuelles et collectives)

Détails

  • Titre original : Oil circulation rate in ejector cooling cycles.
  • Identifiant de la fiche : 30023350
  • Langues : Anglais
  • Source : 5th IIR International Conference on Sustainability and the Cold Chain. Proceedings: Beijing, Chine, 6-8 avril 2018
  • Date d'édition : 06/04/2018
  • DOI : http://dx.doi.org/10.18462/iir.iccc.2018.0010

Liens


Voir d'autres communications du même compte rendu (72)
Voir le compte rendu de la conférence