Transfert de chaleur et de masse sous des conditions de givrage simultané.
[In Japanese. / En japonais.]
Auteurs : ISHIHARA I.
Type d'article : Article
Résumé
Difficulties in formulating a general expression for heat and mass transfer with simultaneous frosting lie in two regions, inside and outside of the frost layer. The former concerns prediction of the properties of the frost, while the latter depends on the mechanism of the phase change process of vapour into fog or snow in the boundary layer. The article describes the frost growth and heat and mass transfer from humid air to a cold vertical plate under natural convection. In the mechanism of the frost formation, the phase change process from water vapour in the humid air to the solid frost is involved. This article, in particular, focuses on the thermodynamic equilibration in the phase change process of the vapour.
Détails
- Titre original : [In Japanese. / En japonais.]
- Identifiant de la fiche : 2006-3100
- Langues : Japonais
- Source : Refrigeration - vol. 81 - n. 942
- Date d'édition : 04/2006
Liens
Voir d'autres articles du même numéro (4)
Voir la source
-
Avancées dans les études sur les phénomènes de ...
- Auteurs : OHKUBO H.
- Date : 04/2006
- Langues : Japonais
- Source : Refrigeration - vol. 81 - n. 942
Voir la fiche
-
Etude sur le transfert de chaleur et de masse. ...
- Auteurs : ISHIHARA I.
- Date : 1991
- Langues : Japonais
- Source : Trans. JAR - vol. 8 - n. 3
Voir la fiche
-
Frost formation and heat transfer on a cold sur...
- Auteurs : KEDZIERSKI M. A.
- Date : 06/2005
- Langues : Anglais
- Source : International Journal of Refrigeration - Revue Internationale du Froid - vol. 28 - n. 4
- Formats : PDF
Voir la fiche
-
Heat transfer characteristics of a thermal ener...
- Auteurs : REGIN A. F., SOLANKI S. C., SAINI J. S.
- Date : 12/2008
- Langues : Anglais
- Source : Renew. sustain. Energy Rev. - vol. 12 - n. 9
Voir la fiche
-
Dynamic modelling of the storage of an encapsul...
- Auteurs : KOUSKSOU T., BEDECARRATS J. P., DUMAS J. P., et al.
- Date : 07/2005
- Langues : Anglais
- Source : Applied Thermal Engineering - vol. 25 - n. 10
Voir la fiche