Résumé
The aim of this research is to elucidate the characteristics of pressure recovery of a two-phase ejector applied to a carbon dioxide heat pump cycle. The effects of the geometric parameters of the ejector on pressure recovery are investigated in this study. The diameter and length of the constant-area mixing tube are varied within ranges of 2.0-3.6 and 2-40 mm, respectively. The maximum pressure recovery is achieved at a distance of approximately 20 mm from the inlet of the mixing tube, irrespective of the diameter of the mixing tube, when the diameter of the nozzle throat is 0.82 mm. In addition, pressure recovery in the mixing section with a diameter of 3.6 mm is less in comparison to those with diameters of 2.0 and 2.5 mm; in the two latter cases, almost the same pressure recovery is observed. The clearance between the nozzle outlet and the inlet of the constant-area mixing tube is varied to compare the constant-area mixing ejector and the constant-pressure mixing ejector. Pressure recovery decreases when the clearance between the nozzle and the inlet of the mixing tube is large. Therefore, the constant-area mixing ejector is preferable for the carbon dioxide heat pump cycle. Finally, the performance of the ejector equipped with a diffuser is investigated; the measured ejector efficiency is 46%, which corresponds to a COP improvement of approximately 23-24%.
Détails
- Titre original : Characteristics of pressure recovery in a two-phase ejector applied to a carbon dioxide heat pump cycle.
- Identifiant de la fiche : 2009-0820
- Langues : Anglais
- Source : 9th IEA Heat Pump Conference 2008: advances and prospects in technology, applications and markets. Conference proceedings [CD-ROM + abstracts].
- Date d'édition : 20/05/2008
Liens
Voir d'autres communications du même compte rendu (45)
Voir le compte rendu de la conférence
Indexation
-
Investigación en laboratorio de diferentes geom...
- Auteurs : HAFNER A., LADAM Y., ANDRESEN T., et al.
- Date : 09/2011
- Langues : Espagnol
- Source : Frío Calor Aire acondicionado - vol. 39 - n. 439
- Formats : PDF
Voir la fiche
-
Experimental investigation of different ejector...
- Auteurs : HAFNER A., LADAM Y., ANDRESEN T., et al.
- Date : 12/04/2010
- Langues : Anglais
- Source : 9th IIR-Gustav Lorentzen Conference on Natural Working Fluids (GL2010). Proceedings. Sydney, Australia, April 12-14, 2010.
- Formats : PDF
Voir la fiche
-
Performance assessment of an off-the-shelf R744...
- Auteurs : MINETTO S., BRIGNOLI R., BANASIAK K., et al.
- Date : 09/2013
- Langues : Anglais
- Source : Applied Thermal Engineering - vol. 59 - n. 1-2
Voir la fiche
-
Investigación experimental sobre el efecto de l...
- Auteurs : NAKAGAWA M., MARASIGAN A. R., MATSUKAWA T., et al.
- Date : 11/2011
- Langues : Espagnol
- Source : Frío Calor Aire acondicionado - vol. 39 - n. 441
- Formats : PDF
Voir la fiche
-
Experimental investigation on the effect of mix...
- Auteurs : NAKAGAWA M., MARASIGAN A. R., MATSUKAWA T., et al.
- Date : 12/04/2010
- Langues : Anglais
- Source : 9th IIR-Gustav Lorentzen Conference on Natural Working Fluids (GL2010). Proceedings. Sydney, Australia, April 12-14, 2010.
- Formats : PDF
Voir la fiche