Share

Transient modelling of an adsorber using finned-tube heat exchanger.

Author(s) : RIFFEL D. B., WITTSTADT U., SCHMIDT F. P., et al.

Type of article: Article

Summary

This paper presents a heat and mass transfer simulation of an adsorber, taking into consideration the geometry of the heat exchanger and the diffusion in the adsorbent medium. In this model, an increment in the direction of heating/cooling fluid containing one (or more) fin pitch was considered. In the domain of this increment, the distribution of the adsorbent temperature was evaluated in the radial and axial directions. The model is validated by experimental data of different adsorbents, volume flows and temperatures. All data were collected in an adsorber test-bench at Fraunhofer ISE. As a result it was found a coefficient of multiple determination of around 0.94 and an error of 20% during the transient. Finally, the model was run on typical operation for cooling application and compared with data from literature. A numerical energy balance was also evaluated. In summary, the results obtained by a independent group shows the same range of confidence of the model developed here, in terms of the tendency of the curves and even the absolute values. [Reprinted with permission from Elsevier. Copyright, 2009].

Details

  • Original title: Transient modelling of an adsorber using finned-tube heat exchanger.
  • Record ID : 2010-1457
  • Languages: English
  • Source: International Journal of Heat and Mass Transfer - vol. 53 - n. 7-8
  • Publication date: 2010/03
  • DOI: http://dx.doi.org/10.1016/j.ijheatmasstransfer.2009.12.001

Links


See other articles in this issue (1)
See the source

Indexing