Share

Experimental study of a control strategy for a cascade air source heat pump water heater.

Author(s) : QU M., FAN Y., LI T., et al.

Type of article: Article

Summary

Cascade air source heat pump water heater is suitable for provide high temperature water under a wide range of outdoor air temperature. Most previous studies focused on the operating characteristics of cascade heat pump system, performance improvement, and the selection of optimal immediate temperature. However, no reported studies on the control strategies for cascade heat pump may be identified. This paper proposed a control strategy for cascade air source heat pump water heater to adjust the load variation. The principle that two stage compression ratio is approximately same is used to determine the intermediate pressure. The intermediate pressure, degree of superheat (DS) and the evaporating temperature were regulated by the compressor, electronic expansion valves (EEV) and the evaporator fan of the low temperature (LT) cycle, respectively, through Proportion Integration Differentiation (PID) controller or proportional controller. The control strategy was experimentally tested over a wide operational range of cascade air source heat pump water heater. The results showed that the controller developed successfully helped realize the control of the intermediate pressure, the DS and the evaporating temperature in terms of control accuracy and sensitivity.

Details

  • Original title: Experimental study of a control strategy for a cascade air source heat pump water heater.
  • Record ID : 30020544
  • Languages: English
  • Source: Applied Thermal Engineering - vol. 110
  • Publication date: 2017/01/05
  • DOI: http://dx.doi.org/10.1016/j.applthermaleng.2016.08.176

Links


See other articles in this issue (49)
See the source

Indexing