3D study of cooling system effect on the heat transfer during polymer injection moulding.
Author(s) : HASSAN H., REGNIER N., LE BOT C., et al.
Type of article: Article
Summary
The aim of the cooling system of a plastic injection mould is to provide thermal regulation in the injection moulding process. When the hot plastic melt enters the mould cavity, it cools down and solidifies by dissipating heat through the cooling system. To study the effect of the cooling system design on the solidification and heat transfer of polymer by injection moulding, a full three-dimensional time-dependent injection moulding numerical analysis is carried out. The configuration studied consists of the mould with cuboids-shape cavity having two different thicknesses. The cooling of the polymer material is carried out by cooling water flowing through horizontal six cooling channels. A numerical model by finite volume is used for the solution of the physical model. A validation of the numerical model is presented. The effect of the cooling channels position and their cross-section shape on the cooling process is carried out. The results indicate that, for the same cross-sectional area and coolant flow rate of the cooling channels, the cooling channels having the form rectangular perform the minimum time required to completely solidify the plastic product. They also indicate that when the cooling channels approach to the product surface, the cooling efficiency increases. [Reprinted with permission from Elsevier. Copyright, 2009].
Details
- Original title: 3D study of cooling system effect on the heat transfer during polymer injection moulding.
- Record ID : 2011-0348
- Languages: English
- Source: International Journal of thermal Sciences - vol. 49 - n. 1
- Publication date: 2010/01
- DOI: http://dx.doi.org/10.1016/j.ijthermalsci.2009.07.006
Links
See other articles in this issue (2)
See the source
Indexing
-
Themes:
Chemical engineering;
Heat transfer - Keywords: Plastic; Heat transfer; Cooling; Solidification; Polymer; Modelling; Injection
-
Heat transfer with mechanically driven thermal ...
- Author(s) : MASSÉ H., ARQUIS E., DELAUNAY D., et al.
- Date : 2004/04
- Languages : English
- Source: International Journal of Heat and Mass Transfer - vol. 47 - n. 8-9
View record
-
Heat-transfer model assessment of chill rolls f...
- Author(s) : KUMPINSKY E.
- Date : 1993/11
- Languages : English
- Source: Ind. eng. Chem. Res. - vol. 32 - n. 11
View record
-
Modeling the effect of cooling system on the sh...
- Author(s) : HASSAN H., REGNIER N., PUJOS C., et al.
- Date : 2010/09
- Languages : English
- Source: Applied Thermal Engineering - vol. 30 - n. 13
View record
-
COOLING OF A POLYMER FILM ON A CYLINDER WITH VA...
- Author(s) : SHAPOVALOV V. M., TYABIN N. V., BEDER L. M.
- Date : 1980
- Languages : Russian
- Source: Inzh.-fiz. Zh. - vol. 38 - n. 1
View record
-
HOW PLASTICS ARE AFFECTED BY THERMAL STRESSES.
- Author(s) : ZARUBAY M.
- Date : 1979
- Languages : Hungarian
- Source: Mua. Gumi - vol. 16 - n. 8
View record