Experimental study on the performance of a mechanical cooling tower fitted with different types of water distribution systems and drift eliminators.
Author(s) : LUCAS M., RUIZ J., MARTÍNEZ P. J., et al.
Type of article: Article
Summary
Water drift emitted from cooling towers is objectionable for several reasons, mainly due to human health hazards. Generation and control of drift depends mostly on the couple of elements water distribution system and drift eliminator. The configuration of these two components not only affects drift but also the cooling tower thermal performance. However, no references regarding the effect of the water distribution system on the cooling tower characteristic have been found in the reviewed bibliography. This paper presents an experimental investigation of the thermal performances of a forced draft counter-flow wet cooling tower fitted with a gravity type water distribution system (GWDS) for six drift eliminators and when no drift eliminator was fitted. The interaction between distribution system and drift eliminators is analyzed. Heat and mass transfer processes taken place in the cooling tower have found to be affected by the mass transfer coefficient and the exchange mass-heat area per unit of cooling tower volume. The comparison between the obtained results and those found in the literature indicates that the pressure water distribution systems type (PWDS) achieve better performances than the GWDS. Maximum averaged differences of 38.66% in terms of cooling tower performance have been obtained between the two water systems. The data registered in the experimental set-up were employed to obtain correlations of the tower characteristic. The outlet water temperature predicted by these correlations was compared with the experimentally registered values, obtaining a maximum averaged difference of plus or minus 1.61% for the water-to-air mass flow ratio correlation and plus or minus 0.95% for the water and air mass flow ratios.
Details
- Original title: Experimental study on the performance of a mechanical cooling tower fitted with different types of water distribution systems and drift eliminators.
- Record ID : 30006033
- Languages: English
- Source: Applied Thermal Engineering - vol. 50 - n. 1
- Publication date: 2013/01
- DOI: http://dx.doi.org/10.1016/j.applthermaleng.2012.06.030
Links
See other articles in this issue (64)
See the source
Indexing
-
Medida experimental del arrastre en torres de r...
- Author(s) : RUIZ J., LUCAS M., MARTÍNEZ P. J., et al.
- Date : 2012/02/22
- Languages : Spanish
- Source: CYTEF 2012. VI Congreso Ibérico y IV Congreso Iberoamericano de Ciencias y Técnicas del Frío, Madrid, España, 22-24 de febrero, 2012.
- Formats : PDF
View record
-
Enhancement of heat exchanges on a condenser us...
- Author(s) : BOULET P., TISSOT J., TRINQUET F., et al.
- Date : 2013/01
- Languages : English
- Source: Applied Thermal Engineering - vol. 50 - n. 1
View record
-
Ways of efficiency increase for cooling towers ...
- Author(s) : SOSNOWSKY S. K., KRAVCHENKO V. P.
- Date : 2013
- Languages : Ukrainian
- Source: Holodil'na Tehnika i Tehnologiâ - n. 4
View record
-
Experimental assessment of flow distributors fo...
- Author(s) : BUSTAMANTE J. G., GARIMELLA S.
- Date : 2019/05
- Languages : English
- Source: International Journal of Refrigeration - Revue Internationale du Froid - vol. 101
- Formats : PDF
View record
-
Experimental research on circumferential inflow...
- Author(s) : GAO M., SUN F. Z., WANG N., et al.
- Date : 2014/03
- Languages : English
- Source: Applied Thermal Engineering - vol. 64 - n. 1-2
View record