Share

Transpiration cooling of a nose cone by various foreign gases.

Author(s) : LIU Y. Q., JIANG P. X., JIN S. S., et al.

Type of article: Article

Summary

The transpiration cooling mechanisms used for thermal protection of a nose cone was investigated experimentally and numerically for various cooling gases. The effects of injection rates, model geometry, inlet temperature and Reynolds number of the main stream were studied for air, nitrogen, argon, carbon dioxide and helium. The experiments used a hot gas wind tunnel with main stream temperature= 375 and 425 K and main stream Re= 4630-10,000. The experimental results indicated that even a small amount of coolant injection drastically reduced the heat transfer from the hot gases with the cooling effectiveness increasing with increasing injection rate, although the increases became smaller as the gas injection rate was further increased. The temperature and cooling effectiveness distribution along the transpiration surface of the nose cone model exhibited similar tendencies for all the coolants employed in present experimental research. The temperature decreased from the stagnation point towards the downstream region, then increased because of the non-uniform mass flow distribution of the coolant and thermal conduction from the metal backplane, whereas the cooling effectiveness variation was the reverse. The local cooling effectivenesses and thermal capacities were found to depend on the coolant thermophysical properties. Two-dimensional numerical simulations using the RNG K-E turbulence model for the main stream flow and the Darcy-Brinkman-Forchheimer momentum equations and thermal equilibrium model for the porous zone compared well with the general features in the experiments. [Reprinted with permission from Elsevier. Copyright, 2010].

Details


Links


See other articles in this issue (5)
See the source

Indexing